Slide the pry bar down to the next nail and repeat until the strip is loose from the floor.
Easy way to remove carpet tack strips.
Then tap it with a hammer until the tack strip pops up.
Discard the old tack strip in a heavy duty trash.
At those points slide a pry bar under the tack strip.
A very easy way to remove carpet tack strip from the basement concrete floor.
Cut a slit in the carpet about 6 inches away from a corner using a carpet knife which is a utility knife with a curved blade.
To easily remove the carpet tack strip move the pry bar near a nail and pry up while gently lifting the end of the tack strip with your other hand.
Roll up the strips and tape them for easy handling.
Carpet tack strips can usually remain in place but look for rust rot or other damage.
Joe is working on a carpet removal project now he is ready to.
With this method you ll never break a strip unless the wood is rotten.
Press the pry bar in order to begin lifting the tack strip.
Once the carpet is removed locate the nails which attach the tack strips to the floor.
Its not that hard with these tips from clay king from aaa flood drying with 28.
To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner.
Hook a crowbar into the slit and pull the corner of the carpet off.
Then grab the carpet by hand and continue to pull it up along an entire wall.
Begin at the top of the stairs.
Roll or fold the strip secure with duct tape and remove it from the room.
Positioning the pry bar at each nail and lifting upward will loosen it from the floor for easy removal.
If you are pulling up carpet from stairs.
Continue like this until you have freed the entire strip.
Repeat until the tack strip is completely removed and discard safely in a trash receptacle so no one is injured.
Those tacks are beyond sharp.
You are likely to find that the tack strip is nailed to the floor about every 6 inches.
Reinsert them beside the next nail on the tack strip and pop that nail out the same way.