Easy Way To Put Vinyl J Channell On

Expansionwhen the temperature changes vinyl siding expands and contracts.

Easy way to put vinyl j channell on.

Drive roofing nails every 8 to 10 in. Ez corner is nailed in place and the j channel just slips into it. With the j channel siding on your vinyl siding you can trim like the pros making your work look seamless. Now every installer can create a good looking low maintenance j channel corner.

Mitering corners of the j channel. Proper installation is critical because vinyl expands and contracts with variations in temperatures. Hold the corner post up a bit and run the j channel beneath it instead. If necessary bend the siding to fit into place.

Next measure and cut the siding to fit the measurements of your soffit and push each panel into the j channel. Hammer the first nail into the nailing slot. Save time save money. Well done installation of the j channel gives the vinyl siding a professional look.

Cut and position an undersill trim if necessary see when to use undersill trim. Miter bottom side j to give a false mitered appearance when. Position the j channel under the window. Ez corners work around windows porch ceilings and soffit wherever j channel is used as a receiver or as trim.

Cut out a 3 4 in. This is a quick corner to install your j channel. Corner posts above the roofline are a notorious source of water infiltration. Through the middle of the slots.

Don t drive them tight. To install vinyl siding to the soffit and fascia area on your home nail lengths of j channel along the inner edge of the fascia leaving the nail heads out about 1 32 to 1 16 of an inch. Installing j channel around windows can be a difficult part of the installation process. Install j channel under the window.

The vinyl siding trim pieces should slide back and forth slightly. Notch in the back of each end and install. Notch in the bottom of side j channels and bend tab. If a corner post is installed tight to the shingles and the j channel dead ends into it any water that runs down the j channel will back up at the post and may find its way into the house.

Cut a 3 4 in. The way to allow for this expansion is to install the corner post down from the soffit or top of the corner.